Dell S6100, Руководство по настройке

Страница: 877 / 1743

Version Description
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Added support for LSP Throttling Enhancement.
Usage Information To configure the number of area addresses on router, use this command. This value must be consistent with
routers in the same area, otherwise the router forms only Level 2 adjacencies. The value must be same among all
the routers to form Level 1 adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
Syntax max-lsp-lifetime seconds
To restore the default time, use the
no max-lsp-lifetime
command.
Parameters
seconds The maximum lifetime of LSP in seconds. This value must be greater than the
lsp-
refresh-interval command. The higher the value the longer the LSPs are kept. The
range is from 1 to 65535. The default is 1200 .
Defaults 1200 seconds
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Usage Information
Change the maximum LSP lifetime with this command. The maximum LSP lifetime must always be greater than
the LSP refresh interval.
The seconds parameter enables the router to keep LSPs for the specified length of time. If the value is higher,
the overhead is reduced on slower-speed links.
Intermediate System to Intermediate System (IS-IS) 877