Dell S6100, Руководство по настройке

Страница: 49 / 1743

DHCP Mode
To enable and configure Dynamic Host Configuration Protocol (DHCP), use DHCP mode. For more information, see Dynamic Host
Configuration Protocol (DHCP) .
To enter DHCP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
ip dhcp server
command. The prompt changes to include
config-dhcp
.
You can return to CONFIGURATION mode by using the
exit
command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, see Dynamic Host Configuration Protocol (DHCP) .
To enter DHCP POOL mode:
1 Verify that you are logged in to DHCP mode.
2 Enter the
pool
command then the pool name. The prompt changes to include
config-dhcp- pool-name
.
You can return to DHCP mode by using the
exit
command.
ECMP GROUP Mode
To enable or configure traffic distribution monitoring on an ECMP link bundle, use ECMP GROUP mode. For more information, see
ecmp_overview .
To enter ECMP GROUP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
ecmp-group
command then enter the ECMP group ID. The prompt changes to include
conf-ecmp-group- ecmp-
group-id
.
You can return to CONFIGURATION mode by using the
exit
command.
EIS Mode
To enable or configure Egress Interface Selection (EIS), use EIS mode.
To enter EIS mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
management egress-interface-selection
command. The prompt changes to include
conf-mgmt-eis
.
You can return to CONFIGURATION mode by using the
exit
command.
EXEC Mode
When you initially log in to the switch, by default, you are logged in to EXEC mode. This mode allows you to view settings and enter EXEC
Privilege mode, which is used to configure the device.
CLI Basics 49