management route
Configure a static route that points to the Management interface or a forwarding router.
Syntax
management route {
ip-address mask
|
ipv6-address 1.1.1.1prefix-length
}
{
forwarding-router-address
| managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the
no management route
command.
Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix format) of the destination
subnet.
ipv6-address prefix-
length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the destination
subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the /x format.
The range is from /0 to /128.
NOTE:
The :: notation specifies successive hexadecimal fields of zeros.
forwarding-router-
address
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a
forwarding router.
managementethern
et
Enter the keyword
managementethernet
for the Management interface on the
Primary RPM.
fortyGigE
Enter the keyword
fortyGigE
to specify a forty Gigbit Ethernet interface.
vlan
Enter the keyword
vlan
to specify a vlan interface.
tengigabitethernet
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Defaults
Not configured.
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
9.0.2.0
Introduced on the S6000.
9.0.0.0
Introduced on the Z9000 and added support for IPv6.
IPv4 Routing
783
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...