Dell S6100, Руководство по настройке

Страница: 774 / 1743

• For a tunnel interface, enter the keyword tunnel then the tunnel interface number.
The range is from 1 to 16383.
If you configure a static IPv6 route using an egress interface and enter the ping command
to reach the destination IPv6 address, the ping operation may not work. Configure the
IPv6 route using a next-hop IPv6 address in order for the ping command to detect the
destination address.
interface ip-address Enter the keyword
interface
then the IP address.
distance (OPTIONAL) Enter the value of the distance metric assigned to the route. The range is
from 1 to 255.
permanent (OPTIONAL) Enter the keyword
permanent
to specify that the route must not be
removed even if the interface assigned to that route goes down. The route must be
currently active to be installed in the routing table. If you disable the interface, the route is
removed from the routing table.
tag tag-value (OPTIONAL) Enter the keyword
tag
then a number to assign to the route. The range is
from 1 to 4294967295.
vrf vrf-name Enter the keyword
vrf
followed by the name of the VRF. Use this VRF option after the
next hop to specify which VRF the next hop belongs to. This setting is used in route
leaking cases. See “R”oute Leaking VRFs” in the Virtual Routing and Forwarding (VRF)
section of the Configuration guide.
weight weight-
value
Enter the keyword
weight
followed by a weight value. The range is from 0 to 255.
NOTE: Weight for a static route can be added only for the destination address
and not for the route pointing to destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
774 IPv4 Routing