Dell S6100, Руководство по настройке

Страница: 399 / 1743

Usage Information To configure a COMMUNITY attribute, use the
set community
command in ROUTE-MAP mode.
In order that settings corresponding to the
neighbor send-community
command take effect, you must
execute the
clear ip bgp
command immediately after you execute the
neighbor send-community
command.
If you do not set any of the optional parameters (standard or extended), then both standard as well as extended
attributes are sent. If you set either the standard or extended parameter, only the attribute that is specified is sent.
neighbor shutdown
Disable a BGP neighbor or peer group.
Syntax neighbor { ip-address | peer-group-name } shutdown
To enable a disabled neighbor or peer group, use the
neighbor { ip-address | peer-group-name }no
shutdown
command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to disable or enable all routers within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
Peers that are enabled within a peer group are disabled when their peer group is disabled.
Border Gateway Protocol 399