Dell S6100, Руководство по настройке

Страница: 951 / 1743

Parameters
seconds Enter a number as the time between FEFD control packets. The range is from 3 to 300
seconds. The default is
15 seconds .
Defaults 15 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Legacy E-Series
command.
Related Commands
• fefd — enable far-end failure detection.
• fefd-global — enable FEFD globally on the system.
fefd-global
Enable FEFD globally on the system.
Syntax fefd-global [interval seconds ][mode {normal | aggressive}]
To disable FEFD globally, use the
no fefd-global [mode {normal | aggressive}]
command.
Parameters
interval seconds Enter the keyword
interval
followed by the number of seconds to wait between FEFD
control packets. Range is from 3 to 300 seconds. Default is 15 seconds.
normal (OPTIONAL) Enter the keywords
mode normal
to change the link state to “unknown”
when a far-end failure the software detects on that interface. When the interface is
placed in “unknown” state, the software brings down the line protocol. The default is
Normal mode .
aggressive (OPTIONAL) Enter the keywords
mode aggressive
to change the link state to “error-
disabled” when a far-end failure the software detects on that interface. When an interface
is placed in “error-disabled” state, t enter the
fefd reset
command to reset the
interface state.
Layer 2 951