Version
Description
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000–ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.11.1
Introduced on the Z9000.
8.1.1.0
Introduced on the E-Series (IPv4).
7.8.1.0
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
7.4.1.0
Introduced on the E-Series.
Usage Information
When all sequence numbers are exhausted, this feature permits re-assigning a new sequence number to entries of
an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter.
Syntax
seq
sequence-number
{deny | permit} {
ip-protocol-number
| icmp | ip | tcp |
udp} {
source mask
| any | host
ip-address
} {
destination mask
| any | host
ip-
address
} [
operator
[
portnumber
|
portname
]] [count [byte] | log] [dscp
value
]
[ecn
value
] [fragments] [monitor [
session-ID
]] [no-drop] [order]
Parameters
sequence-number
Enter a number from 0 to 4294967290.
deny
Enter the keyword
deny
to configure a filter to drop packets meeting this condition.
permit
Enter the keyword
permit
to configure a filter to forward packets meeting this criteria.
ip-protocol-number
Enter a number from 0 to 255 to filter based on the protocol identified in the IP protocol
header.
icmp
Enter the keyword
icmp
to configure an ICMP access list filter.
ip
Enter the keyword
ip
to configure a generic IP access list. The keyword
ip
specifies that
the access list permits all IP protocols.
tcp
Enter the keyword
tcp
to configure a TCP access list filter.
udp
Enter the keyword
udp
to configure a UDP access list filter.
source
Enter an IP address in dotted decimal format of the network from which the packet was
received.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
any
Enter the keyword
any
to specify that all routes are subject to the filter.
220
Access Control Lists (ACL)
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...
