Dell S6100, Руководство по настройке

Страница: 1194 / 1743

port source-port | source-port-range start-port - end-port } {destination-port
destination-port | destination-port-range start-port - end-port }
To delete a filter, use the
no seq sequence-number
command.
Parameters
sequence-number Enter a number from 1 to 65535.
permit Enter the keyword
permit
assign the sequence to the permit list.
redirect Enter the keyword
redirect
to assign the sequence to the redirect list.
ip-address Enter the keyword
IP address
of the forwarding router.
tunnel Enter the keyword
tunnel
to configure the tunnel setting.
tunnel-id Enter the keyword
tunnel-id
to redirect the traffic.
track Enter the keyword
track
to enable the tracking.
track <obj-id> Enter the keyword
track <obj-id>
to track object-id.
ip-protocol-number Enter the keyword
ip-protocol-number
then the number from 0 to 255 for the
protocol identified in the IP protocol header.
protocol-type Enter one of the following keywords as the protocol type:
•
icmp
for internet control message protocol
• ip for any internet protocol
•
tcp
for transmission control protocol
•
udp
for user datagram protocol
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x).
any Enter the keyword
any
to specify that all traffic is subject to the filter.
host ip-address Enter the keyword
host
then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
bit (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following
TCP flags:
•
ack
= acknowledgement
•
fin
= finish (no more data from the user)
•
psh
= push function
•
rst
= reset the connection
•
syn
= synchronize sequence number
•
urg
= urgent field
operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical
operand:
•
eq
= equal to
• neq = not equal to
•
gt
= greater than
•
lt
= less than
1194 Policy-based Routing (PBR)