Dell S6100, Руководство по настройке

Страница: 590 / 1743

Flex Hash and Optimized Boot-Up
This chapter describes the Flex Hash and fast-boot enhancements.
Topics:
• load-balance ingress-port enable
• load-balance flexhash
• reload-type fastboot
• lacp fast-switchover
• encapsulation dot1q
load-balance ingress-port enable
Enable the Flex hash functionality. This utility is supported on the platform.
Syntax
load-balance ingress-port enable
To disable the Flex hash capability, use the no version of this command.
Default None
Command Modes CONFIGURATION mode
Command History
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.3(0.0) Introduced on the S6000 platform.
9.2(1.0) Introduced on the Z9500.
Usage Information Flex hash uses the RTAG7 bins 2 and 3 (overlay bins). These bins must be enabled for Flex hash to be configured.
These bins contain the source module and source port information. These bins are disabled by default in releases of
Dell Networking OS earlier than Release 9.3.0.0. The default behavior of disabling of these bins occurs because of
incorrect egress port information that would otherwise be displayed in the output of the diagnostic show command
of
show ip flow .
As a result, when load balancing of RRoCE packets using Flex hash is enabled, the
show ip flow
command is
not functional. Similarly, when
show ip flow
command operates (ingress port based load balancing is disabled)
the hashing of RRoCE packets is not operational.
Flex hash APIs do not mask out unwanted byte values after extraction of the data from the Layer 4 headers for the
offset value.
Example Dell#load-balance ingress-port enable
15
590 Flex Hash and Optimized Boot-Up