Dell S6100, Руководство по настройке

Страница: 490 / 1743

•
ets-conf:
enables the advertisement of ETS configuration TLVs.
•
ets-reco:
enables the advertisement of ETS recommend TLVs.
•
pfc:
enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can configure the transmission of more than one TLV type at a time; for example:
advertise dcbx-tlv
ets-conf ets-reco
.
You can enable ETS recommend TLVs (
ets-reco
) only if you enable ETS configuration TLVs (
ets-conf
). To
disable TLV transmission, use the
no
form of the command; for example,
no advertise dcbx-tlv pfc
ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
configuration on a port, use the
show interface dcbx detail command.
dcbx port-role
Configure the DCBX port role the interface uses to exchange DCB information.
Syntax dcbx port-role {config-source | auto-downstream | auto-upstream | manual}
To remove DCBX port role, use the no dcbx port-role {config-source | auto-downstream |
auto-upstream | manual}
command.
Parameters
config-source |
auto-downstream |
auto-upstream |
manual Enter the DCBX port role, where:
•
config-source
: configures the port to serve as the configuration source on the
switch.
•
auto-upstream
: configures the port to receive a peer configuration. The
configuration source is elected from auto-upstream ports.
490 Data Center Bridging (DCB)