Dell S6100, Руководство по настройке

Страница: 1163 / 1743

Parameters
interface-cost
Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to
65535.
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on the S4810 and Z9000.
7.8.1.0 Added support for C-Series.
7.4.1.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information
In general, the path cost is calculated as:
10^8 / bandwidth
Using this formula, the default path cost is calculated as:
• GigabitEthernet — Default cost is 1
• TenGigabitEthernet — Default cost is 1
• FortygigEthernet — Default cost is 1
• Ethernet — Default cost is 10
ipv6 ospf dead-interval
Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare
the router down.
Syntax ipv6 ospf dead-interval seconds
To return to the default time interval, use the
no ipv6 ospf dead-interval
command.
Open Shortest Path First (OSPFv2 and OSPFv3) 1163