Acknowledgment Number: 2
Total DCBX Frames transmitted 27
Total DCBX Frames received 6
Total DCBX Frame errors 0
Total DCBX Frames unrecognized 0
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on Ethernet ports that support
converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
Syntax
dcb-map
map-name
To remove a DCB map from an ethernet interface, use the
no dcb-map
command.
Parameters
map-name
Enter a DCB map name. The maximum number of alphanumeric characters is 32.
Defaults
None. There are no pre-configured PFC and ETS settings on S5000 Ethernet interfaces.
Command Modes
CONFIGURATION
INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100-ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.7(0.0)
Introduced on the S6000-ON and Z9500.
9.3(0.0)
Introduced on the S4810 and S6000 platforms.
Usage Information
A DCB map is a template used to configure DCB parameters and apply them on converged Ethernet interfaces.
DCB parameters include priority-based flow control (PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the
show qos dcb-map
name
command.
Use the
dcb-map
command to create a DCB map to specify PFC and ETS settings and apply it on Ethernet ports.
After you apply a DCB map to an interface, the PFC and ETS settings in the map are applied when the Ethernet
port is enabled. DCBx is enabled on Ethernet ports by default.
The
dcb-map
command is supported only on physical Ethernet interfaces.
To remove a DCB map from an interface, enter the
no dcb-map
map-name
command in Interface configuration
mode.
You can enable or disable pfc mode on the DCB mode using the
pfc mode on
or
pfc mode off
command.
Data Center Bridging (DCB)
497
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...