Usage Information
This command is supported on 10/100/1000 Base-T Ethernet interfaces.
You can use the
negotiation auto
command on the 10G ports on the device.
The
no negotiation auto
command is only available if you first manually set the speed of a port to
10Mbits
or
100Mbits
.
The
negotiation auto
command provides a
mode
option for configuring an individual port to forced-master/
forced slave after you enable auto-negotiation.
If you do not use the
mode
option, the default setting is
slave
. If you do not configure forced-master or forced-
slave on a port, the port negotiates to either a master or a slave state. Port status is one of the following:
•
Forced-master
•
Force-slave
•
Master
•
Slave
•
Auto-neg Error — typically indicates that both ends of the node are configured with forced-master or forced-
slave.
CAUTION:
Ensure that one end of your node is configured as forced-master and one is configured as
forced-slave. If both are configured the same (that is, forced-master or forced-slave), the
show
interfaces
command flaps between an auto-neg-error and forced-master/slave states.
You can display master/slave settings with the
show interfaces
command.
Example (Master/
Slave)
Dell(conf)# interface tengigabitethernet 1/1/1/1
Dell(conf-if)# neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)# mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#
Example
(Configured)
Dell# show interfaces configured
TenGigabitEthernet 1/1/3/4 is up, line protocol is up
Hardware is Force10Eth, address is 00:01:e8:05:f7:fc
Current address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
...
User Information
Both sides of the link must have auto-negotiation enabled or disabled for the link to come up.
The following details the possible speed and auto-negotiation combinations for a line between two 10/100/1000
Base-T Ethernet interfaces.
Interfaces
693
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...