snmp-server host
Configure the recipient of an SNMP trap operation.
Syntax
snmp-server host
ip-address
|
ipv6-address
[vrf
vrf-name
] traps | informs
[version 1 | 2c | 3] [auth | no auth | priv] [
community-string
] [udp-port
port-
number
] [
notification-type
]
To remove the SNMP host, use the
no snmp-server host
ip-address
[vrf
vrf-name
] traps |
informs [version 1 | 2c | 3] [auth | noauth | priv] [
community-string
] [udp-
port
number
] [
notification-type
]
command.
Parameters
ip-address
Enter the keyword
host
then the IP address of the host (configurable hosts is limited to
16).
ipv6-address
Enter the keyword host then the IPv6 address of the host in the x:x:x:x::x format.
NOTE:
The :: notation specifies successive hexadecimal fields of zero.
vrf
vrf-name
Enter the keyword
vrf
and then the name of the VRF that the SNMP server uses to
connect to the host.
NOTE:
You can use this attribute to inform the SNMP engine about the vrf
instance to be used to reach the corresponding remote host to send Trap or
Inform message. If no VRF is specified, then the default VRF is used.
traps
(OPTIONAL) Enter the keyword
traps
to send trap notifications to the specified host.
The default is
traps
.
informs
(OPTIONAL) Enter the keyword
informs
to send inform notifications to the specified
host. The default is
traps
.
version 1 | 2c | 3
(OPTIONAL) Enter the keyword version to specify the security model then the security
model version number
1
,
2c
, or
3
:
•
Version
1
is the least secure version.
•
Version
3
is the most secure of the security modes.
•
Version
2c
allows transmission of informs and counter 64, which allows for integers
twice the width of what is normally allowed.
The default is version
1
.
auth
(OPTIONAL) Enter the keyword
auth
to specify authentication of a packet without
encryption.
noauth
(OPTIONAL) Enter the keyword
noauth
to specify no authentication of a packet.
priv
(OPTIONAL) Enter the keyword
priv
to specify both authentication and then scrambling
of the packet.
community-string
Enter a text string (up to 20 characters long) as the name of the SNMP community.
1506
Simple Network Management Protocol (SNMP) and Syslog
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...