Tunneling
Tunneling is supported on Dell Networking OS.
Topics:
•
•
•
•
•
•
•
•
•
•
ip unnumbered
Configure a tunnel interface to operate without a unique IPv4 address and select the interface from which the tunnel borrows its address.
Syntax
ip unnumbered
interface-type
To set the tunnel back to default logical address use the
no ip unnumbered
command. If the tunnel was
previously operational, the tunnel interface is operationally down unless you also configure the tunnel IPv6 address.
Parameters
interface-type
Enter the interface type, followed by a slot/port/subport number.
Defaults
None
Command Modes
INTERFACE TUNNEL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant
Dell Networking
OS Command Line Reference Guide
.
Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.5(0.1)
Introduced on the Z9500.
56
1628
Tunneling
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...