Dell S6100, Руководство по настройке

Страница: 1629 / 1743

Version Description
9.4(0.1) Introduced on the S4810, S4820T, S6000 and Z9000.
9.3(0.1) Introduced on the S5000 and Z9000.
Usage Information
The ip unnumbered command fails in two conditions:
• If the logical ip address is configured.
• If Tunnel mode is ipv6ip (where ip address over tunnel interface is not possible).
To ping the unnumbered tunnels, the logical address route information must be present at both the ends.
NOTE: The
ip unnumbered
command can specify an interface name that does not exist or does not have a configured IPv6
address. The tunnel interface is not changed to operationally up until the logical IP address is identified from one of the address
family.
ipv6 unnumbered
Configure a tunnel interface to operate without a unique IPv6 address and select the interface from which the tunnel borrows its address.
Syntax ipv6 unnumbered {interface-type interface-number}
To set the tunnel back to default logical address use the
no ipv6 unnumbered
command. If the tunnel was
previously operational, the tunnel interface is operationally down unless you also configure the tunnel IPv4 address.
Parameters
interface-type
interface-number
Enter the interface type, followed by the type, and then the slot/port/subport
information.
Defaults None.
Command Modes INTERFACE TUNNEL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
The
ipv6 unnumbered
command fails in two conditions:
• If the logical IP address is configured.
Tunneling 1629