Dell S6100, Руководство по настройке

Страница: 1720 / 1743

Parameters
interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword
twentyFiveGigE
then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword
fiftyGigE
then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword
hundredGigE
then the
stack/slot/port information.
• For a VLAN interface, enter the keyword
vlan
, and then the VLAN ID. The VLAN ID
range is from 1 to 4094.
priority-cost (OPTIONAL) Enter a number as the amount to subtract from the priority value. The range
is from 1 to 254. The default is
10 .
Defaults priority cost = 10
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide .
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER election
if the priority value is lower than the priority value in the BACKUP virtual routers.
virtual-address
Configure up to 12 virtual router IP addresses in the VRRP group. To start sending VRRP packets, set at least one virtual IP address for the
VRRP group.
Syntax virtual-address ip-address1 [ ... ip-address12 ]
1720 Virtual Router Redundancy Protocol (VRRP)