Version
Description
9.10(0.0)
Introduced on the S6100–ON.
9.8(1.0)
Introduced on the Z9100–ON.
9.8(0.0P5)
Introduced on the S4048-ON.
9.8(0.0P2)
Introduced on the S3048-ON.
9.7(0.0)
Introduced on the S6000-ON.
9.2(1.0)
Introduced on the Z9500.
9.0.2.0
Introduced on the S6000.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
8.1.1.0
Introduced on the E-Series.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
Usage Information
You can only configure one domain name with the
ip domain-name
command. To configure more than one
domain name, configure the
ip domain-list
command up to six times.
To enable dynamic resolution of hosts, use the following steps:
•
specify a domain name server with the
ip name-server
command
•
enable DNS with the
ip domain-lookup
command
To view current bindings, use the
show hosts
command.
Related Commands
•
— configure additional names.
ip helper-address
Specify the address of a DHCP server so that DHCP broadcast messages can be forwarded when the DHCP server is not on the same
subnet as the client.
Syntax
ip helper-address
ip-address
To remove a DHCP server address, use the
no ip helper-address
command.
Parameters
ip-address
Enter an IP address in dotted decimal format (A.B.C.D).
Defaults
Not configured.
Command Modes
INTERFACE
764
IPv4 Routing
Содержание S6100
Страница 1: ...Dell Command Line Reference Guide for the S6100 ON System 9 11 2 0P1 ...
Страница 474: ...protocol list ttl0 ttl1 Dell 474 Control Plane Policing CoPP ...
Страница 979: ... show lldp neighbors display the LLDP neighbors Link Layer Discovery Protocol LLDP 979 ...
Страница 1627: ... uplink state group creates an uplink state group and enables the tracking of upstream links Uplink Failure Detection UFD 1627 ...