Appendix 3-1
TI71M01D06-01EN 3rd Edition: 2012.12.01
Details of Main Error Codes
Name
Error
code
Recovery
Cause and condition detected
Action taken
at occurrence
Countermeasure
Memory error
ROM
error
1.1
Not
possible
An error was detected during memory check
Initial
processing
not completed
Cycle the power.
If all uploading has been
complete, initialize the drive.
It is necessary to repair the
drive board.
RAM
error
1.2
Interface board error
2.0
Not
possible
Contact I/O or CC-Link : It failed during the
interface board initialization.
PROFIBUS-DP : It was detected that an incorrect
ID number was assigned. (The ID "0" (the number
for master station) is assigned.) or it failed during
the interface board initialization.
Initial
processing
not completed
Contact I/O or CC-Link :
It is necessary to repair the
drive board.
PROFIBUS-DP :
Set an appropriate number
(other than "0") and cycle the
power.
If the error occurs after
performing the action above,
it is necessary to repair the
drive board.
EEPROM error
3.0
Not
possible
An error was detected in EEPROM that stores data
Initial
processing
not completed
or
deceleration
stopped
Cycle the power.
If all uploading has been
complete, initialize the drive.
It is necessary to repair the
drive board.
Watchdog error
4.0
Not
possible
The drive CPU is not operating properly
Reset the
CPU
(communicati
on operation
set to valid)
Data checksum error
Parameter
checksum
error 10.1
Not
possible
It was detected that the stored data was destroyed
during processing when the power was turned ON.
Initial
processing
not completed
Operation table checksum
error
10.3
I/O setup data checksum
error
10.5
Data error
Motor/drive data error
11.1
Not
possible
It was detected that the setup data could not be
processed during processing when the power was
turned ON.
Initial
processing
not completed
System data error
11.3
Power module mismatch
11.4
Old coordinate system
setup data error
11.5
Error history data error
11.6
Hardware
version
mismatch 11.7