Tektronix MSO54, Programmer'S Manual

Page: 794 / 1026

Commands listed in alphabetical order
Syntax
TRIGger:{A|B}:BUS:B<x>:CAN:IDentifier:MODe
{STandard|EXTended}
TRIGger:{A|B}:BUS:B<x>:CAN:IDentifier:MODe?
Arguments
STandard
speci fi es the standard addressing mode.
EXTended
speci fi es the extended addressing mode.
Examples
TRIGger:A:BUS:B1:CAN:IDentifier:MODe EXTENDED
sets the addressing
mode to extended.
TRIGger:A:BUS:B1:CAN:IDentifier:MODe?
might return
:TRIGGER:A:BUS:B1:CAN:IDENTIFIER:MODE STANDARD
indicating the
address mode is standard.
TRIGger:{A|B}:BUS:B<x>:CAN:IDenti fi er:VALue
This command sets the binary address value to be used when triggering on a CAN
bus signal. The trigger condition must be set to IDANDDATA or DATa (using
TRIGger:{A|B}:BUS:B<x>:CAN:CONDition ). The bus number is speci fi ed
by <x>.
Conditions Requires the SR-AUTO Triggering and Analysis application.
Group Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:CAN:IDentifier:VALue <QString>
TRIGger:{A|B}:BUS:B<x>:CAN:IDentifier:VALue?
Arguments
<QString>
is up to 29 bits specifying the binary identi fi er value. The only
allowed characters in the
QString
are 0, 1, and X.
Examples
TRIGGER:A:BUS:B1:CAN:IDENTIFIER:VALUE "1011"
sets the identi fi er
value to 1011.
TRIGGER:A:BUS:B1:CAN:IDENTIFIER:VALUE?
might return
:TRIGGER:A:BUS:B1:CAN:IDENTIFIER:VALUE "XXXXXXXXXXX"
indicating
the identi fi er values is XXXXXXXXXXX.
2-778 MSO54, MSO56, MSO58, MSO58LP Programmer