Command groups
The programmable interface conforms to Tektronix standard codes and formats
except where noted. The interface also conforms to IEEE Std 488.2-1987 except
where noted.
Acquisition command group
Acquisition commands set up the modes and functions that control how the
instrument acquires signals and processes them into waveforms. Using these
commands for acquiring waveforms, you can do the following:
Start and stop acquisitions.
Control whether each waveform is simply acquired, averaged, or enveloped
over successive acquisitions of that waveform.
Set the controls or conditions that start and stop acquisitions.
Control acquisition of acquired channel waveforms.
Set acquisition parameters.
Table 2-17: Acquisition commands
Command
Description
Queries the current acquisition state.
Sets or queries the waveform grading for fast acquisition mode.
Sets or queries the state of fast acquisition mode.
Returns the maximum real-time sample rate.
Sets or queries the acquisition mode.
Returns the number of waveform acquisitions that have occurred since starting
acquisition with the
ACQuire:STATE RUN
command.
Sets or queries number of acquisitions for an averaged waveform.
In single sequence acquisition mode, this query returns the number of acquisitions
or measurements in the sequence completed so far.
In single sequence acquisition, the single sequence stop after count is based on
number of acquisitions or measurements. Number of acquisitions is the only mode
supported for this product.
In single sequence acquisition mode, specify the number of acquisitions or
measurements that comprise the sequence.
Starts, stops, or returns acquisition state.
Sets or queries whether the acquisition is continuous or single sequence.
MSO54, MSO56, MSO58, MSO58LP Programmer
2-11
Summary of Contents for MSO54
