Commands listed in alphabetical order
on. If these waveform cursors are not on when the DATa SNAp command is sent,
it is silently ignored and DATa:STARt and :STOP remain unchanged.
If either of the cursors is outside the record, DATa:STARt and :STOP are set to
nearest values within the record. This will cause DATa:STARt and/or :STOP to
snap to the beginning or end of the record whichever is nearest, and the following
event is set: 500, "Execution warning", "One or both cursors outside of waveform
record".
If there is no acquired waveform for the cursor source, then DATa:STARt and
:STOP remain unchanged and the following event is set: 500, "Execution
warning", "No acquired waveform record".
If DATa:STARt is greater than :STOP, the values of DATa:STARt and STOp are
swapped and the following event is set: 530, "Data start > stop, Values swapped
internally".
Examples
DATA INIT
initializes the waveform data parameters to their factory defaults.
DATA?
might return
:DATA:DESTINATION REF1;ENCDG RIBINARY;SOURCE
CH1;START 1;STOP 1000;FRAMESTART 1;FRAMESTOP 1000
.
DATa:ENCdg
This command sets or queries the format of outgoing waveform data. This
command is equivalent to setting
and
. Setting the DATa:ENGdg value causes the
corresponding WFMOutpre values to be updated and vice versa.
NOTE.
Values are constrained (for outbound data) to the format of the data
speci
fi
ed by DATa:SOUrce.
Group
Waveform Transfer
Syntax
DATa:ENCdg
{ASCIi|RIBinary|RPBinary|FPBinary|SRIbinary|SRPbinary|SFPbinary}
DATa:ENCdg?
Related Commands
MSO54, MSO56, MSO58, MSO58LP Programmer
2-215
Summary of Contents for MSO54
