Command groups
Horizontal command group
Horizontal commands control the time base of the instrument. You can set the
time per division (or time per point) of the main time base. You can use the
Horizontal commands to do the following:
Set the scale, horizontal position and reference, and units of the time base
Get the screen resolution, time of
fi
rst point and time of last point, or get all
the horizontal settings
Enable or disable the display of the time base
Table 2-29: Horizontal commands
Command
Description
Returns the number of FastFrame frames which have been acquired.
Sets or returns the scale ration for the speci
fi
ed analog channel.
Queries the current horizontal settings.
Returns the time base duration.
Sets or queries the horizontal delay mode.
Sets or queries the horizontal delay time (position) that is used when delay is on.
Returns the number of graticule divisions over which the waveform is displayed.
Returns all information under horizontal:fastframe.
Sets or returns the number of frames.
HORizontal:FASTframe:MAXFRames?
Returns the maximum number of frames.
HORizontal:FASTframe:MULtipleframes:
MODe
Sets or returns the overlay display type.
HORizontal:FASTframe:REF:FRAme
Sets or returns the reference frame number.
HORizontal:FASTframe:REF:INCLUde
Sets or returns whether the reference frame delta information is shown in the display.
Sets or returns the selected frame number for acquired frames.
Sets or returns the state of FastFrame.
HORizontal:FASTframe:SUMFrame?
Sets or returns the summary frame type.
HORizontal:FASTframe:SUMFrame:STATE
Sets or returns the state of FastFrame summary frame.
HORizontal:FASTframe:TIMEStamp:
REFerence?
Returns the time-stamp of the FastFrame Reference frame.
HORizontal:FASTframe:TIMEStamp:
SELECTED?
Returns the time-stamp of the FastFrame Selected acquired frame.
HORizontal:FASTframe:TIMEStamp:DELTa?
Returns the time difference between the Selected and Reference time-stamps.
HORizontal:FASTframe:TIMEStamp:ALL?
Returns the time stamp of all frames.
HORizontal:FASTframe:XZEro:ALL?
Returns the sub-sample time between the trigger sample (designated by PT_OFF)
and the occurrence of the actual trigger for the waveform speci
fi
ed by the
DATa:SOUrce command for all frames.
MSO54, MSO56, MSO58, MSO58LP Programmer
2-35
Summary of Contents for MSO54
