Tektronix MSO54, Programmer'S Manual

Page: 786 / 1026

Commands listed in alphabetical order
TRIGger:A:BUS:B1:AUDio:DATa:VALue?
might
return
:TRIGGER:A:BUS:B1:AUDIO:DATA:VALUE
"XXXXXXXXXXXXXXXXXXXXXXXX"
indicating the data value is
XXXXXXXXXXXXXXXXXXXXXXXX.
TRIGger:{A|B}:BUS:B<x>:AUDio:DATa:WORD
This command sets the alignment of the data (left, right or either) to be used to
trigger on an audio bus signal. The trigger condition must be set to DATa using
TRIGger:{A|B}:BUS:B<x>:AUDio:CONDition .
The bus number is speci fi ed by <x>.
Conditions
Requires the SR-AUDIO Triggering and Analysis application.
Group
Trigger
Syntax
TRIGger:{A|B}:BUS:B<x>:AUDio:DATa:WORD {EITher|LEFt|RIGht}
TRIGger:{A|B}:BUS:B<x>:AUDio:DATa:WORD?
Arguments
EITher
aligns the trigger data to either left or right.
LEFt
aligns the trigger data to the left.
RIGht
aligns the trigger data to the right.
Examples
TRIGger:A:BUS:B1:AUDio:DATa:WORD LEFt
sets the word alignment to
the left.
TRIGger:A:BUS:B1:AUDio:DATa:WORD?
might return
:TRIGGER:A:BUS:B1:AUDIO:DATA:WORD EITHER
indicating the
trigger data is aligned to either left or right.
TRIGger:{A|B}:BUS:B<x>:CAN:CONDition
This command sets the condition (start of frame, frame type, identi fi er, matching
data, EOF, missing ACK fi eld, bit-stuf fi ng error) to be used when triggering on a
CAN bus signal. The bus number is speci fi ed by <x>.
Conditions Requires the SR-AUTO Triggering and Analysis application.
Group
Trigger
2-770 MSO54, MSO56, MSO58, MSO58LP Programmer