Philips IntelliVue Series, Installation And Service Manual

Page: 501 / 522

Data Export - Installation on the Database Server E-1
E
Data Export - Installation on the
Database Server
Overview
Appendix E describes the procedure for installing and activating the Data Export
options:
• Holter option - this feature provides the ability to export a patient’s ECG
waveform data stored on the Database Server to a Philips/Zymed Holter
Scanner for Windows - Model 2010 for Holter analysis via the hospital’s
Network.
• 12-Lead option - this feature provides the ability to export
12-Lead ECG
captured conventional 12-lead ECG to a configured receiving system
Data Export requires the following conditions:
• Philips Application Software Release E.01 installed on the Database Server
and all Information Centers and Clients on the Network.
• The Holter Export and/or 12-Lead Export must be purchased and the
interface configured on the Information Center to recognize the hospital’s
receiving system.
• The hospital’s Holter System must be the Philips/Zymed Holter Scanner for
Windows - Model 2010 running Software Version 2.0 or higher on a
Windows 98, ME or 2000 PC.
The hospital’s Holter PC must also be enabled
to receive the exported patient data from the Information Center/Database
server - refer to the procedures for your specific operating system described at
the end of this section.
• The hospital’s TraceMaster Server must be the running software version
A.04 with Option 40 . The TraceMaster Server must also be enabled to receive
the exported patient data from the Information Center/Database server - refer
to the procedures described at the end of this section.
• A second Network Interface Card (NIC) must be installed.
• A 100 Mbit/s network connection must be made between the Database
Server’s NIC and the hospital’s LAN.
• The hospital must provide the following configuration information for the
Database Server:
– IP Address
– IP Subnet Mask
– Default Gateway
– Host Name(s)
• TCP/IP and HTTP networking protocol on hospital LAN PC’s accessing the
Database Server
• Configuration of Host Name of the Holter System PC (configured via the
Config Wizard)
• Configuration of Host Name of the TraceMaster server (configured via the
Config Wizard)