Philips IntelliVue Series, Installation And Service Manual

Page: 411 / 522

Troubleshooting
Maintenance, Troubleshooting, and Repair
7-125
DO NOT PRESS the keyboard
F10
key .
System Options
Step 9. Select System Options and press Enter to display its menu.
Step 10. Change the following System Options to the values indicated:
• NUMLOCK Power-On State: On
• Embedded NIC Port 1 PXE Support: Disabled
Note If Enabled has been selected, a message will appear. Press Enter again to display its sub
menu and then select Disabled .
Step 11. Press
Esc
to return to the
Setup
menu.
PCI Devices
Step 12. Select PCI Devices and press Enter to display its menu.
Step 13. Change the following PCI Devices to the values indicated:
– PCI Embedded Compaq PCI USB Controller: Disabled
– PCI Embedded 64 Bit Dual Wide Ultra3 SCSI Adapter Port 1: Disabled
– PCI Embedded 64 Bit Dual Wide Ultra3 SCSI Adapter Port 2: Disabled
– PCI Slot 6 Ethernet Network Controller:
IRQ 11
Step 14. Press
Esc
to return to the
Setup
menu.
Note
Steps 15 and 16 may be required to satisfy License requirements.
Date and Time
Step 15. Select Time and Date and press Enter to display the Set Time and Date
window.
Step 16. Set the Time and Date (if incorrect) following the instructions given at the bottom
of the screen.
Advanced Options
Step 17. Select
Advanced Options
and press
Enter
to display its menu.
Step 18. Change the following
Advanced Options
to the values indicated:
– Hot Plug Resources: Disabled
– Post Speed Up:
Disabled
Step 19. Press Esc to return to the Setup menu.
Step 20. Press Esc again to display the message <F10> to Confirm .
Step 21. Press the keyboard F10 key to save the settings and exit the Setup utility.
Step 22. The system will then reboot.