Philips IntelliVue Series, Installation And Service Manual

Page: 220 / 522

Network Names and IP Addresses
5-40
Hardware Installation
Step 6. Highlight the
TCP/IP
in the Protocols window and click on
Properties
brings up
the
Internet Protocol TCP/IP Properties
window of
Figure 5-34
Step 7. Enter an IP Address for this device using one of the Recommended IP
Addresses for that type of device given in Table 5-1 .
Step 8. Enter a
Default Gateway
for this device. Use the factory default value .
Step 9. Click OK to close the Microsoft TCP/IP Properties , OK again to close the
Network window, and then close the Control Panel .
Step 10.
Shutdown
and
Restart
the device to return to the
Windows Main Menu
.
After setting Host Names and IP Addresses , Network Interface Card (NIC)
configurations must also be verified. The following steps give the procedure for verifying
the NIC configuration for the Server.
Step 11. Click on
Start
,
Settings
and
Control Panel
to open the
Control Panel
.
Step 12. Double click on the Network and Dial-up Connections icon to open the
Network and Dial-up Connections window.
Step 13. Right click on the
Hospital LAN
icon and select
Properties.
The Hospital LAN
Properties window shown in
Figure 5-35
opens.
Step 14. Click the Configure button. Click on the Advanced tab.
Step 15. Verify the value in the field shown in Figure 5-37.
Figure 5-37 M3154 Server HLAN Speed/Duplex Setting