Philips IntelliVue Series, Installation And Service Manual

Page: 449 / 522

Configuring the System
Start-up and Configuration
8-7
• When sighting the measured edges of the
Main Screen
, close one eye and use a line-
of-sight that is perpendicular to the ruler.
Note
To obtain a 25 mm/s sweep speed on the Second display, the Primary and Second displays
need to be the same size.
Step 5. Repeat Steps 1-4 for all CRT Displays of the Philips system.
For Flat Panel
Displays
Step 1. Press the PROCEED button on the front panel of the display to bring up the On-
Screen Manager window.
Note
If the
LOCK OUT
mode is displayed, hold down the
PROCEED
button and simultaneously
press and release the
CONTROL
button. Then release the
PROCEED
button.
If the
On-Screen Manager
appears but has the wrong orientation , press and release the
display
EXIT
button and then press the display
RESET
button.
Step 2. Press and release the CONTROL button to highlight Auto .
Step 3. Press and release the
PROCEED
button.
The display will briefly go blank and then reappear. This step automatically adjusts the image
position, horizontal size, and the fine display settings. The borders shall now be centered and
fill the screen.
Note
To reactivate the
ON-Screen Manager LOCKOUT
mode:
• Press
EXIT
twice to activate the
On-Screen Manager
.
• Hold down the
PROCEED
button and simultaneously press and release the
CONTROL
button.
• Immediately press and release the
CONTROL
button.
• Release the
PROCEED
button.
• Skip Step 4 .
Step 4. Press and release the EXIT button.
Step 5. Repeat Steps 1-4 for all Flat Panel Displays of the system.
Verifying
Sweep Speed
Accuracy
Step 1. Verify the accuracy of the 25mm/s setting as follows: