Nortel 425-24T, Configuration Manual, Page: 297 / 488

Chapter 7 System configuration using the CLI 297
System Configuration Guide
The
show clock summer-time
command has no parameters or variables.
Figure 110 displays sample output from the
show clock summer-time
command.
Figure 110 show clock summer-time
Enabling Autopology
You can enable the Optivity* Autopology* protocol using the CLI. Refer to
www.nortel.com/support for information on Autopology. (The product family for
Optivity and Autotopology is Data and Internet.). This section covers the
following commands:
• “autotopology command”
• “no autotopology command” on page 298
• “default autotopology command” on page 298
autotopology command
The
autotopology
command enables the Autotopology protocol. The syntax for
the
autotopology
command is:
autotopology
The
autotopology
command is in the config command mode.
The
autotopology
command has no parameters or values.
425(config)#show clock summer-time
Summer time is set to:
start: 1 April 2006 at 12:00
end: 1 October 2006 at 12:00
Offset: 60 minutes. Timezone will be 'DST'