Nortel 425-24T, Configuration Manual, Page: 267 / 488

Chapter 7 System configuration using the CLI 267
System Configuration Guide
Table 71 describes the parameters and variables for the
configure network
command.
show config-network command
The
show config-network
command displays information regarding the
automatic loading of the configuration file, including the current status of this
feature, the file name, the TFTP server address, and the status of the previous
automatic configuration command.
The syntax for the
show config-network
command is:
show config-network
The
show config-network
command is in the privExec mode.
Table 71 configure network command parameters and variables
Parameters and variables Description
load-on-boot
{disable|use-bootp|use-config Specifies the settings for automatically loading a configuration file when
the system boots:
• disable—disables the automatic loading of config file
• use-boot—specifies using the BootP file as the automatically loaded
config file
• use-config—specifies using the ASCII configuration file as the
automatically loaded config file
Note: If you omit this parameter, the system immediately downloads and
runs the ASCII config file.
filename <WORD> Specifies the file name .
Note: If you omit this parameter and do not specify BootP, the system
uses the configured file name.
address <XXX.XXX.XXX.XXX> Specifies the TFTP server from which to load the file. Enter the IP
address in dotted-decimal notation.
Note: If you omit this parameter and do not specify BootP, the system
uses the configured address.
Note:
When you specify the file name or address, these parameters will
be changed at the next reboot, even if you do not specify load-on-boot.