Nortel 425-24T, Configuration Manual, Page: 220 / 488

220 Chapter 6 System configuration using the Console Interface
320985-A Rev 01
Table 48 describes the SNMP Configuration screen fields.
Table 48 SNMP Configuration screen fields
Field Description
Read-Only
Community String The community string used for in-band read-only SNMP operations.
Default Value public
Range Any ASCII string of up to 32 printable characters
Read-Write
Community String The community string used for in-band read-write SNMP operations.
Default value private
Range Any ASCII string of up to 32 printable characters
Trap #1 IP Address 1
1 The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel proprietary MIB). The status
of the row in the MIB table can be set to Ignore. If the row status is set to Ignore, the fields appear to be set when
viewed from the console terminal; however, no traps are sent to that address until the row status is set to Valid
.
Number one of four trap IP addresses. Successive Trap IP address fields
are numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
Community String The community string associated with one of the four trap IP addresses
(see Trap #1 IP Address).
Default value Zero-length string
Range Any ASCII string of up to 32 printable characters
Authentication Trap Determines whether a trap is sent when there is an SNMP authentication
failure.
Default value Enabled
Range Enabled, Disabled
Autotopology Allows you to enable or disable the switch participation in autotopology,
which allows network topology mapping of other switches in your network.
Default value Enabled
Range Disabled