Nortel 425-24T, Configuration Manual, Page: 287 / 488

Chapter 7 System configuration using the CLI 287
System Configuration Guide
Enabling and disabling autosave
The Ethernet Switch 325/425 performs a check every sixty seconds to detect
changes in the configuration file or a new log message in the non-volatile storage.
If any of these two events occurs, the switch automatically saves it’s configuration
and the non-volatile log to flash memory. Autosave also automatically saves your
configuration information across reboots.
You can enable or disable this feature. When you disable autosave, changes in the
configuration file are not saved to the flash memory.
This section covers the following commands:
• “show autosave command”
• “autosave enable command” on page 288
• “no autosave enable command” on page 288
• “default autosave enable command” on page 288
show autosave command
The
show autosave
command displays the status of the autosave feature, either
enabled or disabled. The syntax for the
show autosave
command is:
show autosave
The
show autosave
command is in the privExec command mode.
The
show autosave
command has no parameters or variables.
Figure 107 displays sample output from the
show autosave
command.
Note:
You can use the CLI command
copy config nvram
to force
a manual save of the configuration when autosave is disabled.