Nortel 425-24T, Configuration Manual, Page: 279 / 488

Chapter 7 System configuration using the CLI 279
System Configuration Guide
The
copy tftp config
command is in the privExec command mode.
Table 79 describes the parameters and variables for the
copy tftp config
command.
Setting the default management interface
You can use
cmd-interface
command to set the default management interface
when you connect to Ethernet Switches 325 and 425 through console port or
Telnet. This selection is stored in NVRAM and propagated to all units in a stack
configuration.
On startup, the switch or stack displays the banner and prompts the user to press
[Ctrl}+y. After entering these characters, the system displays either a menu or the
Nortel Command Line Interface (NCLI) prompt, depending on which is set using
this command.
When using the console port, you must logout for the new mode to display. When
using Telnet, all subsequent Telnet sessions display the selection.
cmd-interface command
The
cmd-interface
command allows you to set the default management
interface when you use the console port or Telnet.
The syntax for the
cmd-interface
command is:
cmd-interface {cli|menu}
The
cmd-interface
command is in the privExec command mode.
Table 79 copy tftp config command parameters and variables
Parameters and
variables
Description
address
<XXX.XXX.XXX.XXX> Specifies the TFTP server IP address; enter in dotted-decimal
notation.
filename <WORD> Enter the name of the configuration file you want to copy from
the TFTP server.