Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 120 / 2354

show mac-learning Source Learning Commands
page 3-12 OmniSwitch CLI Reference Guide March 2011
show mac-learning
Displays Source Learning MAC Address Table information.
show mac-learning [summary] [multicast | static | dynamic] [vlan vlan_id [-vlan_id2]] [slot slot | port
slot/port] [linkagg linkagg] [mac-address mac_address]
Syntax Definitions
summary Displays summary of all the parameters.
multicast Display all the static multicast MAC addresses information contained in
the MAC address table.
static Display static MAC addresses with a permanent status.
dynamic Display dynamically learned MAC addresses.
vlan_id [-vlan_id2] A contiguous range of VLAN ID numbers (for example, 5-10).
slot Enter the slot number for a module to specify that the command must
include all ports on that module (for example, 6 specifies all ports on the
module found in slot 6 of the switch chassis).
slot/port Enter the slot number and the physical port number on that module
(for example, 3/1 specifies port 1 on slot 3).
linkagg Enter a link aggregate ID number. See Chapter 6, “Link Aggregation
Commands.”
mac_address Enter a MAC Address (for example, 00:00:39:59:f1:0c).
Defaults
By default, information is displayed for all MAC addresses contained in the table.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Note that only one VLAN entry - a single VLAN ID or a range of VLAN IDs is allowed with this
command. Multiple VLAN entries are not accepted.
•
If a static MAC address is configured on a port link that is down or disabled, an asterisk appears to the
right of the MAC address in the
show mac-learning command display. The asterisk indicates that this
is an invalid MAC address. When the port link comes up, however, the MAC address is then
considered valid and the asterisk no longer appears next to the address in the display.