Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1404 / 2354

show ip dvmrp neighbor DVMRP Commands
page 22-24 OmniSwitch CLI Reference Guide March 2011
show ip dvmrp neighbor
Displays the DVMRP neighbor table. The DVMRP neighbor table displays either all neighboring DVMRP
routers, or a specified neighboring DVMRP router.
show ip dvmrp neighbor [ip_address]
Syntax Definitions
ip_address Specifies a particular IP address for a neighboring DVMRP router.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
If a neighbor IP address is not specified, the entire DVMRP Neighbor Table is displayed.
Examples
-> show ip dvmrp neighbor
Neighbor Address Intf Name Uptime Expires GenID Vers State
----------------+-------------+-----------+-----------+----------+------+-------
143.209.92.214 vlan-2 00h:09m:12s 00h:00m:06s 546947509 3.255 active
Release History
Release 7.1.1; command was introduced.
output definitions
Neighbor Address The 32-bit IP address of the DVMRP neighbor’s router interface.
Itnf Name The interface name of the neighbor’s router.
Uptime The amount of time the neighbor has been running, displayed in hours,
minutes, and seconds.
Expires The amount of time remaining before the neighbor expires, displayed in
hours, minutes, and seconds.
GenID The generation ID for the DVMRP neighbor. This value is used by
neighboring routers to detect whether the DVMRP routing table should
be resent.
Version The DVMRP version number for the neighbor.
State The current state of the DVMRP neighbor. Options include active and
down .