Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1306 / 2354

ipv6 multicast version IP Multicast Switching Commands
page 21-48 OmniSwitch CLI Reference Guide March 2011
ipv6 multicast version
Sets the default version of the MLD protocol on the specified VLAN or on the system if no VLAN is spec-
ified.
ipv6 multicast [vlan vid] version [version]
Syntax Definitions
vid VLAN on which to apply the configuration.
version Default MLD protocol version to run. Valid range is 1 to 2.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the default MLD protocol version on the
system and/or the specified VLANs.
•
If the default MLD protocol version is already configured on the system, then the VLAN configuration
will override the system's configuration.
•
Due to protocol inter-operation requirements, this command specifies only a default version of the
MLD protocol to run.
•
To restore the MLD multicast version to the default (i.e., 1) version on the system if no VLAN is speci-
fied, use
ipv6 multicast version followed by the value 0 (e.g., ipv6 multicast version 0) or use
only ipv6 multicast version (e.g., ipv6 multicast version).
•
To restore the MLD multicast version to the default (i.e., 1) version on the specified VLAN, use
ipv6 multicast vlan vid version followed by the value 0 (e.g., ipv6 multicast vlan 2 version 0) or use
only ipv6 multicast vlan vid version (e.g., ipv6 multicast vlan 2 version).
Examples
-> ipv6 multicast version 2
-> ipv6 multicast version 0
-> ipv6 multicast version
-> ipv6 multicast vlan 2 version 2
-> ipv6 multicast vlan 2 version 0
-> ipv6 multicast vlan 2 version
Release History
Release 7.1.1; command was introduced.
parameter default
version 1