Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1334 / 2354

ipv6 multicast robustness IP Multicast Switching Commands
page 21-76 OmniSwitch CLI Reference Guide March 2011
ipv6 multicast robustness
Sets the MLD robustness variable on the specified VLAN or on the system if no VLAN is specified.
ipv6 multicast [vlan vid] robustness [robustness]
Syntax Definitions
vid VLAN on which to apply the configuration.
robustness MLD robustness variable. Valid range is 1 to 7.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
IPv6 Multicast Switching and Routing must be enabled to set the MLD robustness variable on the
system and/or the specified VLANs.
•
If the MLD robustness variable is already configured on the system, then the VLAN configuration will
override the system's configuration.
•
Robustness variable allows fine-tuning on the network, where the expected packet loss would be
greater.
•
To restore the MLD robustness variable to its default (i.e., 2) value on the system if no VLAN is speci-
fied, use
ipv6 multicast robustness followed by the value 0 (e.g., ipv6 multicast robustness 0) or use
only ipv6 multicast robustness (e.g., ipv6 multicast robustness).
•
To restore the MLD robustness variable to its default (i.e., 2) value on the specified VLAN, use
ipv6 multicast vlan vid robustness followed by the value 0 (e.g., ipv6 multicast vlan 2 robustness 0)
or use only ipv6 multicast vlan vid robustness (e.g., ipv6 multicast vlan 2 robustness).
Examples
-> ipv6 multicast robustness 3
-> ipv6 multicast robustness 0
-> ipv6 multicast robustness
-> ipv6 multicast vlan 2 robustness 3
-> ipv6 multicast vlan 2 robustness 0
-> ipv6 multicast vlan 2 robustness
Release History
Release 7.1.1; command was introduced.
parameter default
robustness 2