Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1135 / 2354

BGP Commands show ip bgp neighbors
OmniSwitch CLI Reference Guide March 2011 page 19-167
show ip bgp neighbors
Displays the configured IPv4 BGP peers.
show ip bgp neighbors [ ip_address ]
Syntax Definitions
ip_address A 32-bit IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
There are two output options for this command. If you specify show ip bgp peer without a peer IP address,
then you see summary information for all peers known to the local BGP speaker. If you enter a specific
peer IP address with the command, then you see detailed parameter information for that peer only.
Examples
-> show ip bgp neighbors
Legends:Nbr = Neighbor
As = Autonomous System
Nbr address As Admin state Oper state BgpId Up/Down
---------------+-----+-----------+------------+---------------+-----------
192.40.4.29 3 enabled estab 192.40.4.29 00h:14m:48s
192.40.4.121 5 disabled idle 0.0.0.0 00h:00m:00s
output definitions
Nbr address The IP address for this BGP peer. Assign this address through the ip
bgp neighbor command.
As The autonomous system to which this peer belongs. A peer’s AS num-
ber is assigned through the
ip bgp neighbor remote-as command.
Admin state Indicates whether this peer has been enabled or disabled through the ip
bgp neighbor admin-state command.
Oper state The current BGP state for this peer. Possible states are idle , connect ,
active , opensent , openconfirm , and established .
BgpId The unique BGP identifier of the peer. This value is configured
through the
ip bgp neighbor update-source command.
Up/Down The time since this peer has transitioned to its current UP or DOWN
state. If the peer is currently Established, then this is the time that the
peer has been UP. If the peer is currently Idle, then this is the time the
peer has been DOWN.