Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 565 / 2354

IPv6 Commands ipv6 interface
OmniSwitch CLI Reference Guide March 2011 page 11-5
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete an interface.
•
When you create an IPv6 interface, it is enabled by default.
•
All IPv6 VLAN and tunnel interfaces must have a name.
•
When creating an IPv6 interface you must specify a VLAN ID or Tunnel ID. When modifying or
deleting an interface, you do not need to specify one of these options unless the name assigned to the
interface is being changed. If it is present with a different value from when the interface was created,
the command will be in error.
•
A default 6to4 tunnel named “tunnel_6to4” is automatically created. It can only be enabled/disabled or
it configuration modified, it cannot be deleted.
•
A 6to4 interface cannot send advertisements ( ra-send ).
•
To enable IPv6 routing you must first create a VLAN, then create an IPv6 interface on the VLAN. See
Chapter 4, “VLAN Management Commands,” for information on creating VLANs.
•
To route IPv6 traffic over an IPv4 network, you must create an IPv6 tunnel using the ipv6 interface
command.
parameter default
ra-send yes
ra-max-interval 600
ra-managed-config-flag false
ra-reachable-time 0
ra-retrans-timer 0
ra-default-lifetime calculated
ra-min-interval calculated
ra-send-mtu no
ra-clock-skew 600
base-reachable-time 360
retrans-timer 1000
dad-transmits 1
ra-other-config-flag false
ra-hop-limit 64