Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 442 / 2354

ip service port IP Commands
page 10-24 OmniSwitch CLI Reference Guide March 2011
ip service port
Configures a user-defined TCP/UDP service port for the specified service.
ip service {service_name} port {default | service_port}
Syntax Definitions
service_name The name of the TCP/UDP service to enable or disable. (Refer to the
table in the “Usage Guidelines” section below for a list of supported
service names.)
service_port A TCP/UDP service port number (Refer to the table in the “Usage
Guidelines” section below for a list of supported service names.) Valid
range is the default service port number or 20000-20999.
default Sets the port back to the well-known port for the specified service.
Defaults
By default, the service uses the well-known TCP/UDP port number for that service.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the default parameter with this command to set the port for the specified service back to the well-
known default port for that service. For example, if the FTP port was previously changed to “20000”,
then the
ip service ftp port default command would set the FTP port back to “21”.
•
The following table lists the ip service port command options for specifying TCP/UDP services and
also includes the default well-known port number associated with each service:
Note that ntp and snmp services are not supported with the ip service port command.
•
Use the ip service command to enable or disable the status for a well-known or user-defined TCP/UDP
service port.
Examples
-> ip service ftp port 20000
-> ip service ftp port default
service name port
ftp 21
ssh 22
telnet 23
http 80
https 443