Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 451 / 2354

IP Commands ip route-map match ip address
OmniSwitch CLI Reference Guide March 2011 page 10-33
ip route-map match ip address
Matches the route with the specified IPv4 address or an address defined in the specified IPv4 access list.
ip route-map route-map-name [sequence-number number] match ip-address {access-list-name |
ip_address/prefixLen [redist - control {all-subnets | no-subnets | aggregate}] [permit | deny]
no ip route-map route-map-name [sequence-number number] match ip-address {access-list-name |
ip_address/prefixLen [redist - control {all-subnets | no-subnets | aggregate}] [permit | deny]
Syntax Definitions
route-map-name The name of the route map.
number A number that links together the route maps. The range is 1–100.
access-list-name The name of an IPv4 access list that contains IPv4 addresses to match.
ip_address/prefixLen The destination IP address along with the prefix length of the routes to
be redistributed.
all-subnets Redistributes all the subnet routes that match the network portion of the
IP address as specified by the mask length.
no-subnets Redistributes only those routes that exactly match the IP address and the
mask length.
aggregate Redistributes an aggregate route if there are one or more routes that
match the IP address.
permit Permits a route based on the IP address or prefix constrained by redist-
control.
deny Denies a route based on the IP address or prefix constrained by redist-
control.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete the match ip-address redist-control parameter in the route
map.
•
Specify either the name of an existing IPv4 access list or an IPv4 address/prefix length with this
command.
parameter default
number 50
permit | deny permit