Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1197 / 2354

BGP Commands show ipv6 bgp neighbors
OmniSwitch CLI Reference Guide March 2011 page 19-229
Release History
Release 7.1.1; command was introduced.
Neighbor route-reflector-client Indicates whether this peer is a client to the local route reflector, if
configured.
Neighbor confederation status Indicates whether this peer is a member of a BGP confederation.
Neighbor remove private AS Indicates whether the stripping of private AS numbers (64512 to
65535) from AS paths is enabled or disabled.
Neighbor default originate Indicates whether peer default origination is enabled or disabled.
When enabled, the local BGP speaker advertises the default route to
the peer. This value is configured through the
ipv6 bgp neighbor
default-originate command.
Neighbor maximum prefixes The maximum number of prefixes the local router can receive in
UPDATE from this peer. This value is configured through the
ipv6
bgp neighbor maximum-prefix command.
Neighbor max prefixes
warning Indicates whether a warning will be issued when this peer exceeds 80
percent of the maximum prefix value. This value is configured through
the
ipv6 bgp neighbor update-source command.
# of prefixes received Displays the total number of prefixes received by this neighbor.
Neighbor MD5 key When present, shows an encrypted version of the MD5 password.
When not present, and MD5 password has not been configured.
Neighbor local port The TCP port used for the session with this peer.
Neighbor TCP window size The size of the TCP window for this BGP session. This value will
always be 32768 as that is the maximum size of a BGP message.
Graceful Restart State Indicates the graceful restart state. This feature does not support IPv6
prefixes.
Advertised Restart Interval Indicates the restart interval in seconds.
Forwarding State during
restart
Indicates whether the peer has preserved the forwarding state
during the graceful restart.
Activate IPv6 unicast Indicates whether or not IPv6 unicast advertisements are enabled.
Options include
enabled or disabled .
Configured IPv4 NextHop
Address Specifies the IPv4 nexthop address. This is specified using the ipv6
bgp neighbor ipv4-nexthop command.
Configured IPv6 NextHop
Address Specifies the IPv6 nexthop address. This is specified using the ipv6
bgp neighbor ipv6-nexthop command.
Neighbor Ipv6 unicast
Indicates whether or not IPv6 unicast capability is advertised
between the peers. Options include
enabled
or
disabled
.
output definitions (continued)