Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 735 / 2354

BFD Commands show ip bfd interfaces
OmniSwitch CLI Reference Guide March 2011 page 14-27
show ip bfd interfaces
Displays the BFD interface configuration table.
show ip bfd interfaces [if_name]
Syntax Definitions
if_name The name of the BFD interface.
Defaults
By default, the configuration for all BFD interfaces is displayed.
Platforms Supported
OmniSwitch 10K
Usage Guidelines
Enter an interface name to display information for a specific BFD interface.
Examples
-> show ip bfd interfaces
Interface Admin Tx Min Rx Min EchoRx Detect OperStatus
Name Status Interval Interval Interval Multiplier
---------+--------+---------+---------+----------+----------+----------
one enabled 300 300 300 3 UP
two enabled 300 300 300 3 UP
-> show ip bfd interfaces one
Interface Name = one,
Interface IP Address = 100.1.1.1,
Admin Status = Enabled,
Desired Transmit Interval = 300,
Minimum Receive Interval = 300,
Detection Time Multiplier = 3,
Minimum Echo Receive Interval = 300,
Authentication Present = No,
Oper Status = UP
output definitions
Interface Name Refers to BFD Interface name.
Admin status Refers to BFD interface admin status.
Desired Transmit Interval Refers to BFD interface Tx interval.
Minimum Receive Interval Refers to BFD interface Rx interval.
Detection Time Multiplier Refers to BFD interface Detection Time Multiplier.
Minimum Echo Receive Inter-
val Refers to BFD interface echo Rx interval.