Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1683 / 2354

QoS Policy Commands policy condition destination ipv6
OmniSwitch CLI Reference Guide March 2011 page 26-43
policy condition destination ipv6
Configures a destination IPv6 address for a policy condition.
policy condition condition_name destination ipv6 {any | ipv6_address [mask netmask]}
policy condition condition_name no destination ipv6
Syntax Definitions
condition_name The name of the condition.
any Any destination IPv6 address.
ipv6_address A specific destination IPv6 address.
netmask The mask for the source IPv6 address.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to remove a destination IPv6 address from a condition; however, at
least one classification parameter must be associated with a condition.
•
If a mask is not specified, the IPv6 address is assumed to be a host address.
Examples
-> policy condition cond3 destination ipv6
::1234:531F:BCD2:F34A
Release History
Release 7.1.1; command was introduced.
Related Commands
qos apply Applies configured QoS and policy settings to the current configuration.
policy condition Creates a policy condition.
show policy condition Shows information about a particular policy condition configured on the
switch.