Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 1504 / 2354

ipv6 pim interface PIM Commands
page 23-90 OmniSwitch CLI Reference Guide March 2011
stub Specifies the interface not to send any IPv6 PIM packets through this
interface, and to ignore received IPv6 PIM packets.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete an IPv6 PIM interface.
•
IPv6 PIM must be enabled globally on the switch before IPv6 PIM will begin running on the interface.
To globally enable or disable IPv6 PIM-SM on the switch, refer to the
ipv6 pim sparse admin-state
command on page 23-75 . To enable or disable IPv6 PIM-DM on the switch, refer to the ipv6 pim
dense admin-state command on page 23-76 .
•
Specifying zero for IPv6 PIM hello-interval represents an infinite time, in which case the periodic IPv6
PIM hello messages are not sent.
•
Specifying zero for IPv6 PIM joinprune-interval represents an infinite time, in which case the periodic
IPv6 PIM joinprune messages are not sent.
•
Specifying the value of 65535 for IPv6 PIM hello-holdtime represents an infinite time. If an IPv6 PIM
router gets IPv6 PIM Hello packet from a neighbor with its hello-holdtime value as infinte time, then
the router will not time out the sender(neighbor). It is recommended that you use an IPv6 PIM hello-
holdtime interval that is 3.5 times the value of the IPv6 PIM hello-interval, or 65535 seconds if the
IPv6 PIM hello-interval is set to zero
•
Specifying the value of 65535 for IPv6 PIM joinprune-holdtime represents an infinite time. The receipt
of IPv6 Join/Prune messages with its joinprune-holdtime value as infinte time, then this specifies an
infinite holdtime for the particular IPv6 join/prune message. It is recommended that you use a join-
prune- holdtime interval that is 3.5 times the value of the IPv6 PIM Join/Prune interval defined for the
interface, or 65535 seconds if the IPv6 PIM joinprune-interval is set to zero.
parameter default
hello-interval seconds 30
triggered-hello seconds 5
joinprune-interval seconds 60
hello-holdtime seconds 105
joinprune-holdtime seconds 210
prune-delay milliseconds 500
override-interval milliseconds 2500
dr-priority priority 1
prune-limit-interval seconds 60
graft-retry-interval seconds 3
stub Disabled