Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 948 / 2354

show ipv6 ospf OSPFv3 Commands
page 18-26 OmniSwitch CLI Reference Guide March 2011
Release History
Release 7.1.1; command was introduced.
output definitions
Status Displays whether OSPFv3 is currently enabled or disabled on the
router.
Router Id The unique identification for the router.
# Areas Number of areas to which the router belongs.
# Interface Number of interfaces participating in OSPF
Area Border Router Displays whether the router status is an area router or not.
AS Border Router Displays whether the area Autonomous System Border Router status of
this router is enabled or disabled.
External Route Tag Displays the route tag for this router.
SPF Hold (seconds) Displays the time in seconds between the reception of an OSPFv3
topology change and the start of a SPF calculation.
SPF Delay (seconds) Displays the time in seconds between consecutive SPF calculations.
MTU Checking Displays whether Maximum Transfer Unit checking is enabled or dis-
abled. This is set using the
ipv6 ospf mtu-checking command.
# SPF calculations performed Displays the number of SPF calculation performed.
Last SPF run (seconds ago) N/A
Full state Displays the number of neighbor routers that are in Full state.
Loading state Displays the number of neighbor routers that are in Loading state.
Exchange state Displays the number of neighbor routers that are in Exchange state.
Exstart state Displays the number of neighbor routers that are in Exstart state.
2way state Displays the number of neighbor routers that are in 2way state.
Init state Displays the number of neighbor routers that are in Init state.
Attempt state Displays the number of neighbor routers that are in Attempt state.
Down state Displays the number of neighbor routers that are in Down state.