Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 954 / 2354

show ipv6 ospf lsdb OSPFv3 Commands
page 18-32 OmniSwitch CLI Reference Guide March 2011
show ipv6 ospf lsdb
Displays Link State Advertisements (LSAs) in the Link State Database (LSDB) associated with each area.
show ipv6 ospf lsdb [area area_id] [rtr | net | netsum | asbrsum] [linkstate-id ls_id] [router-id
router_id]
Syntax Definitions
area_id A unique 32-bit value in IP address format.
rtr Specifies router LSAs.
net Specifies network LSAs.
netsum Specifies network summary LSAs.
asbrsum Specifies Autonomous System Border Router summary LSAs.
ls_id The Link state ID. The ID is a unique 32-bit value, such as an IP
address. This number is used as a record in the link state database.
router_id The Router ID. The ID is a unique 32-bit value such as an IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command is used to display the LSDB of the OSPF router. It can be used for OSPF debugging,
specifically to narrow down sections of an area to determine which sections are receiving the specified
LSAs. You can specify the parameters of only the area LSDB using the optional command parameters.
•
You can view LSAs by specifying either a link state identifier or a router identifier. However, when
specifying a router ID, you also need to supply a valid link state ID.