Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 2238 / 2354

configuration error-file-limit Configuration File Manager Commands
page 44-4 OmniSwitch CLI Reference Guide March 2011
configuration error-file-limit
Specifies the maximum number of configuration error files allowed in the switch’s /flash directory. Error
files are normally generated when a configuration file is applied to the switch. Error files are identified by
their
.err extension.When the maximum number of .err files is exceeded, any new error file will over-
write the .err file with the oldest timestamp.
configuration error-file-limit number
Syntax Definitions
number Indicate the number of error files allowed in the /flash directory. The
valid range is from 1 to 25 files.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
When the error file limit is set to 1 (the default value), the next error file generated by the switch will
replace the existing one.
•
When the error file limit is set to a value greater than 1, when a new error file that exceeds the
maximum limit is created, the switch will automatically remove the error file with the smallest times-
tamp.
•
The error files generated by the switch have the .err extension.
•
If you want to save an error file, you may change the file name so that it does not have the .err
extension, or you can move it from the /flash directory.
Examples
-> configuration error-file-limit 2
-> configuration error-file-limit 1
Release History
Release 7.1.1; command was introduced.
parameter default
number 1