Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 893 / 2354

OSPF Commands show ip ospf host
OmniSwitch CLI Reference Guide March 2011 page 17-59
show ip ospf host
Displays information on the configured OSPF hosts.
show ip ospf host [ip_address]
Syntax Definitions
ip_address A 32-bit IP address for a directly attached host.
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command is used to display general information for OSPF hosts directly attached to this router.
•
See the Related Commands section below to modify the list.
Examples
-> show ip ospf host 172.22.2.115
Host Address TOS Metric Status AreaId
-----------------+-------+-----------+--------+-----------------
143.209.92.12 1 0 Up 0.0.0.0
Release History
Release 7.1.1; command was introduced.
output definitions
Host Address A 32-bit IP address for a directly attached host. This can be set using
the
ip ospf host command.
ToS The Type of Service traffic from the host is labeled as. ToS is set using
the
ip ospf host command.
Metric The metric assigned to the host. Metric is set using the ip ospf host
command.
Status Whether the host is enabled or disabled.
AreaId The area identification for the host’s area.