Alcatel-Lucent 060321-10, Rev. B, Cli Reference Manual

Page: 457 / 2354

IP Commands ip route-map match ipv6-nexthop
OmniSwitch CLI Reference Guide March 2011 page 10-39
ip route-map match ipv6-nexthop
Matches any routes that have an IPv6 next-hop router address permitted by the specified access list name
or the IPv6 address specified in the route map.
ip route-map route-map-name [sequence-number number] match ipv6-nexthop
{access-list-name | ipv6_address/prefixLen [permit | deny]}
no ip route-map route-map-name [sequence-number number] match ipv6-nexthop
{access-list-name | ipv6_address/prefixLen [permit | deny]}
Syntax Definitions
route-map-name The name of the route map.
number A number that links together the route maps. The range is 1–100.
access-list-name The access list that matches the route nexthop IPv6 address.
ipv6_address/prefixLen The IPv6 address along with the prefix length that matches any nexthop
IPv6 address within the specified subnet.
permit Permits a route based on the IPv6 nexthop.
deny Denies a route based on the IPv6 nexthop.
Defaults
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
Use the no form of this command to delete the match ipv6-nexthop parameter in the route map.
•
If the best matching nexthop is type deny, then the route is not redistributed. If the best matching
nexthop is type permit but the route map action is deny, the route is not redistributed.
•
All route maps having the same name but different sequence numbers are linked together and
processed in order of increasing sequence number.
•
The route-map-name , sequence-number, and access-list-name must exist before you configure this
match criteria.
parameter default
number 50
permit | deny permit